Device.WebUI
Instead of a numeric IP address, some routers use Device.WebUI as a memorable web address for the admin panel. Enter it in your browser to access the login page.
Quick Access
adminCredentials may vary by ISP or custom setup. Check the sticker on your router for your specific device.
What is Device.WebUI?
Device.WebUI is a local web address that gives you access to the admin panel of your router. This address only works when you are connected to the router's network.
Compared to a numeric IP address, Device.WebUI is easier to remember and is provided by the manufacturer as a convenient alternative for accessing the settings page.
How to access the router login page
- 1
Make sure your device (computer, phone, or tablet) is connected to the router — either via Wi-Fi or with an Ethernet cable plugged directly into the router.
- 2
Open a browser and enter your router's IP address in the address bar. The address is usually printed on a sticker on the bottom or back of the device.
- 3
Wait for the login page to appear. This may take a few seconds.
- 4
Enter admin as the username. The password is usually unique to your device — check the sticker on the back of the router or your ISP documentation.
- 5
After logging in, you will see the router dashboard where you can manage all settings.
Troubleshooting
Cannot reach Device.WebUI in your browser? Hostname resolution issues, incorrect credentials, and network configuration problems are among the most common causes. Use the steps below to diagnose and fix the issue.
⚠Device.WebUI does not open — try the IP address
If the hostname does not resolve, try using the numeric IP address instead. Some network configurations or DNS settings may prevent the hostname from working.
⚠Login credentials are not accepted
The default credentials may have been changed by you or your ISP. Check the sticker on the back of the router for the current password. If it was changed and you cannot remember it, a factory reset will restore the defaults.
⚠The page loads very slowly or times out
Disable any VPN or proxy settings on your device. Try a different browser or use incognito/private mode. Clear the browser cache. If you are connected via Wi-Fi, try using an Ethernet cable instead.
⚠Firewall or security software blocking access
Some antivirus or firewall software may block access to local IP addresses. Temporarily disable the firewall and try again. On company or managed devices, your IT department may have restricted access to the admin page.
⚠How to reset the router to factory settings
Locate the small reset button on the back of the router (you may need a paperclip). Press and hold it for at least 10 seconds until the LEDs start blinking. The router will restart with the factory defaults, including the original login credentials.
Example screens
Interface screenshots for this device will be added soon.