SilverCrest Extender Login

Log in to your SilverCrest Extender extender

1. 1

   Make sure your device (computer, phone, or tablet) is connected to the extender — either via Wi-Fi or with an Ethernet cable plugged directly into the extender.

2. 2

   Open any web browser and type https://repeater.setup into the address bar. Press Enter. If the page does not load, try 192.168.1.1 or 192.168.0.1 instead.

3. 3

   Wait for the login page to appear. This may take a few seconds.

4. 4

   Enter admin as the username and admin as the password. Then click the login button.

5. 5

   After logging in, you will see the extender dashboard where you can manage all settings.

Change the Wi-Fi name on a SilverCrest Extender extender

1. 1

   Log in to the extender admin panel as described above.

2. 2

   Open the Wi-Fi or wireless settings. Depending on the model, the menu may be called "WLAN", "Wireless", or "Wi-Fi".

3. Example path (may vary by model): Settings > Wireless settings > Wireless settings.

4. 3

   Find the field for the network name (often labeled SSID or Network Name) and enter the new name.

5. 4

   Click Save or Apply to confirm the changes.

6. 5

   Your devices will need to reconnect using the new network name.

Change the Wi-Fi password on a SilverCrest Extender extender

1. 1

   Log in to the extender admin panel.

2. 2

   Open the Wi-Fi security settings. Look for a section called "Security", "Wireless Security", or "WLAN" in the menu.

3. Example path (may vary by model): Settings > Wireless settings > Wireless settings.

4. 3

   Enter a new Wi-Fi password in the password or passphrase field. Choose a strong password with at least 12 characters, mixing letters, numbers, and symbols.

5. 4

   Click Save or Apply to confirm the changes.

6. 5

   All connected devices will need to reconnect using the new password.

If the login page does not open

Having trouble accessing your SilverCrest Extender extender settings? Connection issues, rejected credentials, and slow-loading admin pages are common problems. Below are the most frequent issues and how to fix them quickly.

⚠repeater.setup is not reachable

Make sure your device is connected directly to the extender, preferably via Ethernet cable. Double-check the address for typos. Try restarting the extender and wait about 30 seconds before trying again.

⚠Login credentials are not accepted

The default credentials may have been changed by you or your ISP. Check the sticker on the back of the extender for the current password. If it was changed and you cannot remember it, a factory reset will restore the defaults.

⚠The page loads very slowly or times out

Disable any VPN or proxy settings on your device. Try a different browser or use incognito/private mode. Clear the browser cache. If you are connected via Wi-Fi, try using an Ethernet cable instead.

⚠Wrong IP address?

Some devices use a different default address. Try these alternatives: 192.168.1.1, 192.168.0.1, 192.168.100.1. You can also find the correct gateway address in the network settings of your operating system.

⚠How to reset the extender to factory settings

Locate the small reset button on the back of the extender (you may need a paperclip). Press and hold it for at least 10 seconds until the LEDs start blinking. The extender will restart with the factory defaults, including the original login credentials.

Example screens

Frequently asked questions